Greater Vancouver’s Trusted HVAC Experts Since 1999 · 4.8★ (221 reviews)

Why Won’t My Furnace Start After a Power Outage?

TSBC-Licensed Gas Contractor · Gas LGA0202903Licensed, Bonded & InsuredServing Greater Vancouver since 19994.8★ (221 Google reviews)
Speak with a licensed ROMA technician todayCall (604) 704-0300Free Estimate
Quick answer: After a power outage, a furnace often won’t start because a breaker tripped, the furnace power switch is off, the thermostat lost its settings or batteries, or a control board or ignition lockout needs resetting. Check the breaker, the furnace switch, and the thermostat first. If it still won’t start, or you smell gas, call a licensed technician. Call ROMA at (604) 704-0300 or book a free estimate.

Power flickers or a full outage in Greater Vancouver, and now your furnace won’t come back on. This is common, and the fix is often simple. Work through these safe checks in order before calling for service.

Safe DIY Checks (In Order)

Get a Quick Quote — Right Here

Fast response from a licensed ROMA technician — no obligation.









4.8★ from 221+ Google reviews · Licensed & insured · TSBC LGA0202903

Prefer to talk now? Call (604) 704-0300

  1. Check the thermostat: Confirm it’s set to Heat and a few degrees above room temperature. If it’s a battery model, the outage may have drained or reset it; replace the batteries and re-enter your settings.
  2. Check the furnace power switch: Most furnaces have a switch that looks like a light switch on or near the unit. A surge or bump can flip it off. Make sure it’s on.
  3. Check the breaker: Find the furnace breaker in your electrical panel. If it’s tripped (in the middle or off position), switch it fully off, then back on.
  4. Wait and let it reset: After power returns, give the furnace a couple of minutes. Many units run a start-up sequence before the burner lights.
  5. Check the furnace door panel: A safety switch prevents the furnace from running if the front panel isn’t seated properly. Make sure it’s fully closed.

Try a Controlled Reset

📞 Talk to a licensed ROMA technician — (604) 704-0300

If those checks don’t do it, you can try a full reset: turn the thermostat off, switch the furnace power switch off, wait about 30 seconds, then turn the power switch on and the thermostat back to Heat. Power surges can put the control board or ignition system into a lockout that a reset clears.

Common Causes Explained

CauseWhat Happened
Tripped breakerThe surge when power returned overloaded the circuit
Ignition lockoutControl board locked out after failed start attempts
Thermostat resetSettings or batteries were lost during the outage
Blown fuse on control boardA surge damaged the low-voltage fuse
Damaged control boardA strong surge harmed furnace electronics

When to Stop and Call a Professional

Stop and call a licensed technician if: the furnace still won’t start after these steps, it starts then shuts off repeatedly, you see error codes flashing on the unit, or the breaker trips again immediately. Most importantly, if you ever smell gas, leave the home right away and call the gas utility’s emergency line or 911 from outside; do not flip switches. Do not open sealed furnace panels or touch gas or high-voltage components yourself.

What About Smart Thermostats?

Wi-Fi and smart thermostats can behave differently after an outage than a basic model. Some need to reconnect to your home network before they resume normal scheduling, and a router or modem that takes longer to reboot than the thermostat can leave it stuck showing an offline icon even though the furnace itself is fine. If your smart thermostat appears unresponsive, check that your home network is back online first, then confirm the thermostat has power and is calling for heat, before assuming the furnace itself has a fault.

Preventing Outage-Related Failures

A surge protector on the furnace circuit and a well-maintained system reduce outage headaches. Annual service also catches weak components before they fail under stress. Our HVAC maintenance plans keep your furnace reliable through storm season. If your furnace still won’t start, our furnace repair team, all Red Seal-trained, can help, and we offer prompt service 7 days a week. For an aging or failing unit, our furnace specialists can advise on replacement. Book a free estimate or contact us in Burnaby.

Rather have a licensed pro handle it? Fast, honest help across Greater Vancouver.Call (604) 704-0300Free Estimate

Longer Outages and Backup Heat

During an extended outage in colder months, especially in a storm-prone stretch of Greater Vancouver, keeping the home safely warm without power can become its own challenge even after the furnace itself would otherwise work fine. A battery backup or generator sized for your furnace’s blower and control board can keep heat running through a longer outage, but sizing and installation should be reviewed by a licensed electrician alongside your HVAC technician. Never run a generator indoors or in an attached garage, and never use a gas oven, stove, or outdoor barbecue for indoor heat, since these create a serious carbon monoxide risk.

Need a licensed Greater Vancouver HVAC team?

ROMA Heating & Cooling has served Metro Vancouver since 1999 — TSBC-licensed (Gas LGA0202903), bonded & insured, 4.8★ from 221 Google reviews. Upfront flat-rate pricing, free estimates, 0% financing (OAC), 7 days a week.

📞 Call (604) 704-0300Get a Free Estimate

Frequently Asked Questions

Why did my breaker trip when the power came back?

The surge of power returning can briefly overload the furnace circuit and trip the breaker. Reset it once by switching it fully off then on. If it trips again immediately, stop and call a technician.

How do I reset my furnace after an outage?

Turn the thermostat off, switch the furnace power switch off, wait about 30 seconds, then turn the power back on and set the thermostat to Heat. This clears many ignition lockouts caused by surges.

Can a power surge damage my furnace?

Yes. A strong surge can blow the control board’s low-voltage fuse or damage the board itself. A surge protector on the furnace circuit helps prevent this. If electronics are damaged, a technician should repair them.

My furnace starts then shuts off after the outage. What's wrong?

Repeated short-cycling can point to an ignition, flame-sensor, or airflow issue triggered by the outage. After trying a basic reset, have a licensed technician diagnose it rather than forcing repeated restarts.

Reviewed by the ROMA Heating & Cooling team — TSBC-licensed gas contractor (Gas LGA0202903), serving Greater Vancouver since 1999. Updated June 2026.

What Greater Vancouver Homeowners Say

4.8/5 from 221+ verified Google reviews

“Nelson worked hard to get the NTI unit fixed. He was always polite, courteous and on time.”

Chris Tipple · Verified Google review

“As always Nelson was super efficient. Showed up on time and was quick to work. I had a full maintenance done on the fireplaces and furnace. He was awesome. I won’t use anyone else.”

Tammy D · Verified Google review

“Excellent service. Andy had a spare Carrier inducer with him which saved us time.”

Steven E · Verified Google review

“Was very prompt to respond to our issues. Technician was scheduled for the day following my initial call.”

jason l · Verified Google review

“Very professional heating company. Price is reasonable, excellent work.”

Jessica Feng · Verified Google review

“Highly recommend this company. It was a pleasure dealing with Shawn and Nelson.”

Charlotte Stipp · Verified Google review

“Professional and courteous technicians with attention to detail and customer needs.”

Ted Laursen · Verified Google review

“Always great, friendly service. Serviced the hot water on-demand system. Honest and informative. Thanks!”

Wah Gee · Verified Google review

“Speedy response time, honest, and professional service from start to finish.”

Lauren McCaughey · Verified Google review

Read more reviews Call (604) 704-0300

Request Your Free Estimate

Fast response from a licensed ROMA technician — no obligation.









4.8★ from 221+ Google reviews · Licensed & insured · TSBC LGA0202903

Prefer to talk now? Call (604) 704-0300

Why Greater Vancouver Trusts ROMA Heating & Cooling

ROMA Heating & Cooling has installed, repaired and maintained heating and cooling systems across Metro Vancouver since 1999. Our team are TSBC-licensed gas fitters (Gas LGA0202903) and Red Seal-trained technicians — licensed, bonded and insured — and we back every job with upfront, flat-rate pricing and a 100% satisfaction guarantee. We hold a 4.8★ rating from 221+ Google reviews.

  • Authorized for 30+ brands (Lennox, Carrier, Viessmann, Navien, Rheem & more)
  • Upfront flat-rate pricing — no overtime or hidden fees
  • Free, no-obligation estimates on new installations
  • Locally owned & operated in Burnaby, BC

No Hidden Fees

Our service rates are transparent and easy to understand. You approve upfront, flat-rate pricing before we start — so you never get a bill you didn’t expect.

Licensed & Bonded

ROMA is a TSBC-licensed gas contractor (Gas LGA0202903). Our technicians are bonded, insured and Red Seal-trained — qualified for any heating or cooling system.

Free Estimates

We offer free, no-obligation estimates on new installations — furnaces, boilers, heat pumps, air conditioners, tankless and hot-water tanks.

ROMA Heating & Cooling is a trusted HVAC contractor serving Metro Vancouver since 1999. We specialize in furnace repair, heat pump installation, boiler services, air conditioning, and emergency heating solutions for residential, commercial, and government clients. Available for same-day and after-hours service, our certified technicians deliver fast, reliable, and affordable HVAC services across Greater Vancouver.

2800 Douglas Rd B Burnaby, BC V5C 5B7
Monday, Tuesday, Wednesday, Thursday, Friday, Saturday9:00 am – 8:00 pm
(604) 704-0300
(604) 704-0300
1999
50
Free in-home consultation across Greater Vancouver. Planning an installation, replacement, or not sure what you need? ROMA Heating & Cooling has helped Lower Mainland homeowners since 1999 — no obligation, no pressure. Request your free consultation or call (604) 704-0300.
Call Now Book Now
Emergency
Call NowFree Estimate
Scroll to Top