Samsung Heat Pump Refrigerant Recharge in Greater Vancouver
Samsung heat pumps — including the Wind-Free, EHS (Eco Heating System), and AE series — are precision inverter systems that depend on the correct refrigerant charge to deliver their rated efficiency. When refrigerant is lost through a leak, capacity falls, the compressor works harder, and over time the unit can sustain serious internal damage. ROMA Heating & Cooling provides professional Samsung refrigerant leak detection, repair, and recharge across Greater Vancouver, with certified technicians and OEM-compliant refrigerant handling, since 1999.
Why Samsung Heat Pumps Lose Refrigerant
Refrigerant does not deplete through normal operation — any loss indicates a leak. The most common leak points on Samsung heat pump systems include:
- Flare joints at the lineset connections — the most frequent leak site, especially on installations where the flare was not formed to manufacturer tolerance or tightened correctly.
- Service valve cores — the Schrader-style valve cores on both the high- and low-pressure service ports can weep over time.
- Brazed joints — weak or porous welds in the copper lineset, typically from the original installation.
- Coil micro-leaks — rare on new units but possible in older equipment exposed to corrosive environments, such as coastal Metro Vancouver properties.
- Reversing valve body — internal leakage on high-cycle systems in heating-dominated climates like Greater Vancouver.
Samsung Refrigerant Recharge: ROMA’s Process
- Refrigerant pressure measurement — static and operational pressures confirm whether the charge is low and by how much.
- Leak detection — electronic leak detector and nitrogen pressure test to find all leak points before any refrigerant is added.
- Leak repair — re-flaring joints, replacing valve cores, or brazing as required.
- Evacuation — the system is pulled to a deep vacuum to remove air and moisture before recharge.
- Recharge to OEM specification — Samsung specifies charge weight by model; we charge by weight, not pressure alone, using the correct refrigerant type (R-410A or R-32).
- Operational verification — the system is confirmed at rated capacity in both heating and cooling mode before the job is closed.
Samsung Refrigerant Types and Models
| Samsung Series | Common Refrigerant | Notes |
|---|---|---|
| Wind-Free (newer models) | R-32 | Lower GWP, increasing common in 2019+ units |
| Wind-Free (earlier models) | R-410A | Still the most common in Metro Vancouver stock |
| EHS (Eco Heating System) | R-410A / R-32 | Depends on model year; check nameplate |
| AE Series (older ducted) | R-410A | Most units in Greater Vancouver installed before 2020 |
Signs Your Samsung Heat Pump Needs a Refrigerant Recharge
- Reduced heating output — the system runs but the home does not reach setpoint
- Ice forming on the outdoor coil outside of a normal defrost cycle
- Higher-than-normal electricity bills with no change in usage
- A low-pressure fault or refrigerant circuit error code on the indoor display
- The outdoor compressor running continuously without shutting down
Serving Greater Vancouver from Burnaby
ROMA Heating & Cooling has held gas and refrigerant certifications since 1999. We perform Samsung heat pump refrigerant service across Vancouver, Burnaby, Surrey, Richmond, Coquitlam, New Westminster, North Vancouver, West Vancouver, Delta, Langley, and surrounding Metro Vancouver communities. For a prompt diagnosis, call (604) 704-0300 or email info@romaheating.ca.
What Our Customers Say
“Roma has been doing annual checks and cleaning of my gas furnace and heat pump for years. Always on time.”
— Erik Johannes, Google review (★★★★★)
“Nelson arrived at our house one day after requesting an appointment, and solved our heat pump issue within half an hour during a heat wave.”
— Gordon Francis, Google review (★★★★★)
Frequently Asked Questions
How do I know if my Samsung heat pump needs a refrigerant recharge?
Signs include reduced heating or cooling capacity, ice forming on the outdoor coil even when it is not in defrost mode, the outdoor unit running continuously without reaching setpoint, or the system displaying a low-pressure fault. A proper diagnosis by a certified technician is the only way to confirm low refrigerant.
Can I just top up refrigerant without finding the leak?
No. Refrigerant does not deplete on its own — a loss always means a leak somewhere in the system. Adding refrigerant without locating and sealing the leak is a short-term fix that will fail again, and venting refrigerant to atmosphere is illegal. ROMA finds the leak first, seals it, then recharges to Samsung’s OEM specification.
What refrigerant do Samsung heat pumps use?
Most current Samsung EHS and Wind-Free units use R-410A or R-32, depending on model year and series. R-32 is increasingly common in newer units. ROMA technicians carry the correct refrigerant for the model being serviced and always charge to the manufacturer’s specification.
Is low refrigerant dangerous for my Samsung heat pump?
Operating with low refrigerant stresses the compressor — the system runs harder to compensate for lower refrigerant pressure, leading to elevated compressor temperatures, premature wear, and eventual compressor failure, which is far more costly than a timely recharge.
How long does a refrigerant recharge take?
For a straightforward case with a small, accessible leak, the repair and recharge typically takes two to three hours. Larger leaks or hard-to-reach joints may require additional time. ROMA provides an honest time and cost estimate before starting work.
Related Guides & Services
- Heat Pump Not Heating
- Heat Pump Not Cooling
- Heat Pump Maintenance
- Heat Pump Leak Detection & Repair
- Emergency HVAC Repair
Call ROMA Heating & Cooling Today
For fast, professional diagnosis and repair anywhere in Greater Vancouver, call (604) 704-0300 or email info@romaheating.ca. prompt and after-hours service, gas-licensed and insured, serving the Lower Mainland since 1999.
What Greater Vancouver Homeowners Say
“Nelson worked hard to get the NTI unit fixed. He was always polite, courteous and on time.”
“As always Nelson was super efficient. Showed up on time and was quick to work. I had a full maintenance done on the fireplaces and furnace. He was awesome. I won’t use anyone else.”
“Excellent service. Andy had a spare Carrier inducer with him which saved us time.”
“Was very prompt to respond to our issues. Technician was scheduled for the day following my initial call.”
“Very professional heating company. Price is reasonable, excellent work.”
“Highly recommend this company. It was a pleasure dealing with Shawn and Nelson.”
“Professional and courteous technicians with attention to detail and customer needs.”
“Always great, friendly service. Serviced the hot water on-demand system. Honest and informative. Thanks!”
“Speedy response time, honest, and professional service from start to finish.”
Why Greater Vancouver Trusts ROMA Heating & Cooling
ROMA Heating & Cooling has installed, repaired and maintained heating and cooling systems across Metro Vancouver since 1999. Our team are TSBC-licensed gas fitters (Gas LGA0202903) and Red Seal-trained technicians — licensed, bonded and insured — and we back every job with upfront, flat-rate pricing and a 100% satisfaction guarantee. We hold a 4.8★ rating from 221+ Google reviews.
- Authorized for 30+ brands (Lennox, Carrier, Viessmann, Navien, Rheem & more)
- Upfront flat-rate pricing — no overtime or hidden fees
- Free, no-obligation estimates on new installations
- Locally owned & operated in Burnaby, BC
No Hidden Fees
Our service rates are transparent and easy to understand. You approve upfront, flat-rate pricing before we start — so you never get a bill you didn’t expect.
Licensed & Bonded
ROMA is a TSBC-licensed gas contractor (Gas LGA0202903). Our technicians are bonded, insured and Red Seal-trained — qualified for any heating or cooling system.
Free Estimates
We offer free, no-obligation estimates on new installations — furnaces, boilers, heat pumps, air conditioners, tankless and hot-water tanks.
ROMA Heating & Cooling is a trusted HVAC contractor serving Metro Vancouver since 1999. We specialize in furnace repair, heat pump installation, boiler services, air conditioning, and emergency heating solutions for residential, commercial, and government clients. Available for same-day and after-hours service, our certified technicians deliver fast, reliable, and affordable HVAC services across Greater Vancouver.

