Lennox Furnace Tune-Up Across Greater Vancouver
A furnace tune-up is more than a quick look — it is a systematic cleaning, adjustment, and verification process that restores a Lennox furnace to the performance it was designed to deliver. Skipping annual tune-ups allows combustion efficiency to drift, wear items to silently degrade, and safety-critical components like the heat exchanger and flame sensor to go uninspected. ROMA Heating & Cooling has tuned Lennox furnaces across Greater Vancouver since 1999, with the instruments and experience to optimize every model in the lineup.
What Sets a ROMA Lennox Tune-Up Apart
Many tune-up services are limited to a visual check and a filter swap. ROMA’s tune-up is instrument-based and adjustment-oriented — we don’t just look, we measure and correct. This means using a calibrated combustion analyzer on every visit, cleaning components rather than just inspecting them, and testing the furnace through a full operating cycle before we leave.
Complete Lennox Tune-Up Checklist
- Burner assembly cleaning — Burners are removed and cleaned of carbon deposits that reduce heat output and cause ignition irregularities.
- Flame sensor cleaning — The flame sensor (rectifier rod) is cleaned with fine abrasive to restore full microamp signal strength — the single most effective step in preventing nuisance lockouts.
- Hot surface igniter check — We test the igniter for resistance (ohms) to flag failing igniters before they cause a no-heat call.
- Combustion analysis — A flue-gas analyzer measures CO, CO₂, O₂, and flue temperature. Results are compared to Lennox factory combustion specifications.
- Heat exchanger inspection — We visually inspect the primary and secondary heat exchanger sections for cracks, corrosion, or deterioration — a critical safety check for carbon monoxide risk.
- Inducer motor check — We listen and measure for proper inducer operation and bearing wear.
- Blower motor and wheel cleaning — A dirty blower wheel reduces airflow significantly, cutting system efficiency. We inspect and clean as needed.
- Condensate system service — On 90%+ AFUE Lennox models, we flush the condensate drain, clean the trap, and verify proper drainage.
- Pressure switch testing — We test pressure switch operation to confirm it will open correctly under fault conditions.
- Venting inspection — We inspect flue pipe and PVC vent connections, clearances, and termination conditions.
- Filter replacement — We replace the air filter and advise on the correct replacement schedule for your specific Lennox model and filter type.
- Full operational cycle test — We cycle the furnace through a complete start-heat-shutdown sequence and verify all safeties function correctly.
Tune-Up Timing — Metro Vancouver’s Heating Season
| Month | Recommendation |
|---|---|
| September–October | Ideal — pre-season, parts lead time available if needed |
| November–December | Acceptable — busy season, book early |
| January–March | Mid-season — still worthwhile if not done in fall |
| April–August | Off-season — easiest to book, good for multi-year-missed furnaces |
Serving Greater Vancouver from Burnaby
ROMA dispatches tune-up technicians from our Burnaby headquarters across all of Metro Vancouver: Vancouver, Burnaby, New Westminster, Coquitlam, Port Coquitlam, Port Moody, Surrey, Delta, Langley, Abbotsford, Mission, Maple Ridge, Pitt Meadows, North Vancouver, and West Vancouver. We offer morning and afternoon appointment windows to fit your schedule.
Book Your Lennox Furnace Tune-Up
A tune-up now costs far less than an emergency repair call in January. Call ROMA Heating & Cooling at (604) 704-0300 or email info@romaheating.ca to schedule your Lennox furnace tune-up before Metro Vancouver’s heating season peaks.
What Our Customers Say
“I had no heat and after three other companies failed to fix my furnace, a friend recommended Roma Heating.”
— Sima Mann, Google review (★★★★★)
“My furnace stopped working right when the weather dropped and they managed to fit me in the prompt.”
Rather have a licensed pro handle it? Fast, honest help across Greater Vancouver.Call (604) 704-0300Free Estimate— Tj Max, Google review (★★★★★)
Frequently Asked Questions
What is the difference between a furnace tune-up and a maintenance visit?
The terms are often used interchangeably. At ROMA, a tune-up specifically includes all cleaning and adjustment steps — burner cleaning, flame sensor cleaning, combustion analysis, and efficiency optimization — not just an inspection. The goal is to leave your Lennox furnace operating at peak performance, not just to confirm it is running.
How much can a tune-up improve my Lennox furnace’s efficiency?
A furnace operating with a dirty flame sensor, fouled burners, or a partially blocked heat exchanger can operate well below its rated AFUE. A tune-up restoring combustion to factory parameters can reduce gas consumption by 5–15% in some cases.
When is the best time to book a Lennox tune-up in Metro Vancouver?
Early fall — September or October — before the main heating season is ideal. This allows any parts issues found during the tune-up to be resolved before cold weather sets in. ROMA books up quickly in October, so earlier is better.
My Lennox furnace is running fine — do I still need a tune-up?
A furnace can run inefficiently or unsafely without triggering obvious symptoms. Combustion efficiency and heat-exchanger condition cannot be assessed without instruments. A yearly tune-up catches issues that are invisible to the homeowner.
Does ROMA check carbon monoxide during a Lennox tune-up?
Yes. Our combustion analysis includes CO measurement in the flue gases. We also visually inspect the heat exchanger and recommend a CO detector installation if one is not present in your home.
Related Guides & Services
- Furnace Not Heating
- Prompt No-Heat Furnace Repair
- Furnace Control Board Error Codes
- Furnace Tune-Up
- Goodman Furnace Error Codes
- Furnace Troubleshooting & Repair
Call ROMA Heating & Cooling Today
For fast, professional diagnosis and repair anywhere in Greater Vancouver, call (604) 704-0300 or email info@romaheating.ca. prompt and after-hours service, gas-licensed and insured, serving the Lower Mainland since 1999.
What Greater Vancouver Homeowners Say
“Nelson worked hard to get the NTI unit fixed. He was always polite, courteous and on time.”
“As always Nelson was super efficient. Showed up on time and was quick to work. I had a full maintenance done on the fireplaces and furnace. He was awesome. I won’t use anyone else.”
“Excellent service. Andy had a spare Carrier inducer with him which saved us time.”
“Was very prompt to respond to our issues. Technician was scheduled for the day following my initial call.”
“Very professional heating company. Price is reasonable, excellent work.”
“Highly recommend this company. It was a pleasure dealing with Shawn and Nelson.”
“Professional and courteous technicians with attention to detail and customer needs.”
“Always great, friendly service. Serviced the hot water on-demand system. Honest and informative. Thanks!”
“Speedy response time, honest, and professional service from start to finish.”
Why Greater Vancouver Trusts ROMA Heating & Cooling
ROMA Heating & Cooling has installed, repaired and maintained heating and cooling systems across Metro Vancouver since 1999. Our team are TSBC-licensed gas fitters (Gas LGA0202903) and Red Seal-trained technicians — licensed, bonded and insured — and we back every job with upfront, flat-rate pricing and a 100% satisfaction guarantee. We hold a 4.8★ rating from 221+ Google reviews.
- Authorized for 30+ brands (Lennox, Carrier, Viessmann, Navien, Rheem & more)
- Upfront flat-rate pricing — no overtime or hidden fees
- Free, no-obligation estimates on new installations
- Locally owned & operated in Burnaby, BC
No Hidden Fees
Our service rates are transparent and easy to understand. You approve upfront, flat-rate pricing before we start — so you never get a bill you didn’t expect.
Licensed & Bonded
ROMA is a TSBC-licensed gas contractor (Gas LGA0202903). Our technicians are bonded, insured and Red Seal-trained — qualified for any heating or cooling system.
Free Estimates
We offer free, no-obligation estimates on new installations — furnaces, boilers, heat pumps, air conditioners, tankless and hot-water tanks.
ROMA Heating & Cooling is a trusted HVAC contractor serving Metro Vancouver since 1999. We specialize in furnace repair, heat pump installation, boiler services, air conditioning, and emergency heating solutions for residential, commercial, and government clients. Available for same-day and after-hours service, our certified technicians deliver fast, reliable, and affordable HVAC services across Greater Vancouver.

