Lennox Furnace Repair in Surrey, BC
Surrey is the largest and fastest-growing city in Metro Vancouver, and its housing stock reflects that diversity — newer subdivisions in Fleetwood and Morgan Crossing, established family homes in Newton and Guildford, and large acreages in Cloverdale and South Surrey. Lennox furnaces are among the most widely installed brands across all of these neighbourhoods, and ROMA Heating & Cooling has been repairing them throughout Surrey since 1999. Our Burnaby dispatch reaches all of Surrey quickly — prompt on most no-heat calls.
Why Lennox Furnaces Fail in Surrey Homes
Surrey’s rapid population growth means a large proportion of homes have Lennox furnaces installed within the last 10–15 years, many of them high-efficiency 90%+ AFUE units with condensing heat exchangers. These models bring excellent efficiency but also specific failure modes that require informed diagnosis.
- Flame sensor fouling — The flame sensor collects a thin oxide coating over time, causing the furnace to lock out after a few seconds of ignition. Cleaning or replacing the sensor resolves this quickly.
- HSI (hot surface igniter) failure — Silicon nitride igniters on Lennox models are durable but do fail, particularly after several years of thermal cycling. A failed igniter means no ignition at all.
- Condensate drain blockage — Surrey’s cooler winters push high-efficiency furnaces to produce significant condensate. Drain traps and tubing can clog with algae or debris, triggering a pressure-switch lockout.
- Induced-draft motor wear — The draft inducer runs every heating cycle and can develop bearing wear or seal leaks over time, causing either ignition failures or noisy operation.
- Secondary heat exchanger cracks — On older Lennox units, the secondary (condensing) heat exchanger can develop cracks that allow combustion gases into the air stream — a safety issue requiring prompt attention.
Lennox Fault vs Likely Repair
| Symptom | Common Cause | Typical Repair |
|---|---|---|
| Lights then shuts off after a few seconds | Flame sensor fouled | Clean or replace flame sensor |
| No ignition at all | Failed HSI igniter | Replace hot surface igniter |
| Pressure-switch lockout | Condensate drain blocked or inducer weak | Clear drain; inspect inducer |
| Rumbling or grinding noise on start | Inducer motor bearings | Inducer motor replacement |
| CO alarm or smell of exhaust | Heat exchanger crack | Heat exchanger inspection; replace if cracked |
Surrey’s Housing Mix and Furnace Sizing
Surrey’s wide variety of home types — townhouses and condos in Whalley and Guildford, 1980s–2000s detached homes in Newton and Fleetwood, and newer large custom homes in South Surrey — means furnace sizing varies considerably. ROMA technicians are experienced across all Lennox product lines installed in these homes, from the entry-level ML296V to the premium SLP98V variable-speed model. Correct airflow and venting configuration matter in every case, and we verify both on every repair call.
Lennox Models We Repair in Surrey
- SLP98V — variable-capacity, communicating system; modulating gas valve and ECM blower
- EL296V / SL280V — two-stage, high-efficiency; common in mid-range Surrey builds
- ML296V / ML193 — single-stage high-efficiency; widely found in builder-grade Surrey installations
- Older 80% AFUE models — still operating in some pre-2000 Newton and Guildford homes
No DIY on Gas Appliances
Lennox furnace repairs involving the gas valve, heat exchanger, venting, or any sealed combustion component must be performed by a licensed gas contractor. In BC, this means a gas-licensed technician holding a valid certification — which every ROMA technician carries. Attempting to repair these components yourself risks carbon monoxide exposure, gas leaks, and void of insurance.
ROMA’s Repair Process
- Diagnose with fault-code readout and system checks
- Confirm the repair scope and provide upfront pricing
- Complete the repair using OEM or equivalent Lennox parts
- Run combustion analysis and full cycle test before leaving
- Advise on maintenance schedule to prevent future failures
Book Lennox Furnace Repair in Surrey
ROMA Heating & Cooling serves all of Surrey — Guildford, Newton, Fleetwood, Cloverdale, South Surrey, Whalley, and Fraser Heights. Call (604) 704-0300 or email info@romaheating.ca to schedule prompt or next-day Lennox furnace repair.
What Our Customers Say
“My furnace stopped working right when the weather dropped and they managed to fit me in the prompt.”
Rather have a licensed pro handle it? Fast, honest help across Greater Vancouver.Call (604) 704-0300Free Estimate— Tj Max, Google review (★★★★★)
“I got up recently to a non-working furnace. I called ROMA who had serviced it in the past and they were able to come.”
— karen m, Google review (★★★★★)
Frequently Asked Questions
How quickly can ROMA reach Surrey for a Lennox furnace repair?
ROMA dispatches from Burnaby, putting most of Surrey within a short drive. We prioritise no-heat calls and aim for prompt service across the city — from Guildford and Cloverdale to Newton, Fleetwood, and South Surrey.
Are Lennox furnaces common in Surrey homes?
Yes. Lennox is widely sold through Metro Vancouver dealers and features prominently in Surrey’s large builder-grade and custom-home market. Models such as the SLP98V, EL296V, and ML296V are all regularly installed in Surrey subdivisions.
What are the most common Lennox repair issues in Surrey?
Flame sensor fouling, failed HSI (hot surface igniters), secondary heat-exchanger cracks on older models, condensate drain blockages on 90%+ units, and induced-draft motor failures are the most frequent repairs ROMA handles on Surrey Lennox furnaces.
Does ROMA carry Lennox parts for on-site Surrey repairs?
Our technicians stock commonly replaced Lennox components — igniters, flame sensors, pressure switches, and condensate trap assemblies — to resolve most repairs in a single visit rather than waiting on a parts order.
Is it worth repairing my Lennox furnace or should I replace it?
Lennox furnaces under 15 years with a solid maintenance history are generally worth repairing. ROMA gives honest repair-versus-replace guidance based on the unit’s age, fault type, part cost, and BC Hydro or FortisBC rebate eligibility for a new high-efficiency model.
Related Guides & Services
- Furnace Not Heating
- Prompt No-Heat Furnace Repair
- Furnace Control Board Error Codes
- Furnace Tune-Up
- Goodman Furnace Error Codes
- Furnace Troubleshooting & Repair
Call ROMA Heating & Cooling Today
For fast, professional diagnosis and repair anywhere in Greater Vancouver, call (604) 704-0300 or email info@romaheating.ca. prompt and after-hours service, gas-licensed and insured, serving the Lower Mainland since 1999.
What Greater Vancouver Homeowners Say
“Nelson worked hard to get the NTI unit fixed. He was always polite, courteous and on time.”
“As always Nelson was super efficient. Showed up on time and was quick to work. I had a full maintenance done on the fireplaces and furnace. He was awesome. I won’t use anyone else.”
“Excellent service. Andy had a spare Carrier inducer with him which saved us time.”
“Was very prompt to respond to our issues. Technician was scheduled for the day following my initial call.”
“Very professional heating company. Price is reasonable, excellent work.”
“Highly recommend this company. It was a pleasure dealing with Shawn and Nelson.”
“Professional and courteous technicians with attention to detail and customer needs.”
“Always great, friendly service. Serviced the hot water on-demand system. Honest and informative. Thanks!”
“Speedy response time, honest, and professional service from start to finish.”
Why Greater Vancouver Trusts ROMA Heating & Cooling
ROMA Heating & Cooling has installed, repaired and maintained heating and cooling systems across Metro Vancouver since 1999. Our team are TSBC-licensed gas fitters (Gas LGA0202903) and Red Seal-trained technicians — licensed, bonded and insured — and we back every job with upfront, flat-rate pricing and a 100% satisfaction guarantee. We hold a 4.8★ rating from 221+ Google reviews.
- Authorized for 30+ brands (Lennox, Carrier, Viessmann, Navien, Rheem & more)
- Upfront flat-rate pricing — no overtime or hidden fees
- Free, no-obligation estimates on new installations
- Locally owned & operated in Burnaby, BC
No Hidden Fees
Our service rates are transparent and easy to understand. You approve upfront, flat-rate pricing before we start — so you never get a bill you didn’t expect.
Licensed & Bonded
ROMA is a TSBC-licensed gas contractor (Gas LGA0202903). Our technicians are bonded, insured and Red Seal-trained — qualified for any heating or cooling system.
Free Estimates
We offer free, no-obligation estimates on new installations — furnaces, boilers, heat pumps, air conditioners, tankless and hot-water tanks.
ROMA Heating & Cooling is a trusted HVAC contractor serving Metro Vancouver since 1999. We specialize in furnace repair, heat pump installation, boiler services, air conditioning, and emergency heating solutions for residential, commercial, and government clients. Available for same-day and after-hours service, our certified technicians deliver fast, reliable, and affordable HVAC services across Greater Vancouver.

