How much does furnace repair cost in Metro Vancouver?
Furnace repair cost depends on what has actually failed, the furnace's make and age, whether the part is in stock, and how easy the unit is to reach. An igniter or flame sensor is a different job from a draft inducer, control board or gas valve. We diagnose first, then give an upfront flat-rate written quote before any repair.
When the house is cold, most people just want to know what the furnace repair service will cost. Here is what actually moves the number:
- The failed component. Ignition parts, pressure switches, inducer motors, blower motors, control boards and gas valves all differ in parts and labour.
- Part availability. Common parts are often on our trucks. Parts for older or less common furnaces may need ordering, which can mean a second visit.
- Access. Furnaces in attics, crawlspaces or tight condo closets take more time than a basement unit with open floor space around it.
- Venting problems. A blocked or sagging vent, or a condensate trap that freezes on an exterior run, needs correcting at the source, not just a reset.
- The furnace's overall condition. If we find a cracked heat exchanger or a pattern of repeated failures, we'll give you a replacement quote alongside the repair so you can compare.
To get exact pricing, call (604) 704-0300 or email info@romaheating.ca. We'll give you the repair price in writing before we start.
What are the most common winter furnace repairs in Metro Vancouver?
Most winter furnace repairs we do trace back to a handful of causes: dirty flame sensors, failed igniters, blocked condensate drains, inducer or pressure-switch faults, clogged filters and tired blower motors. Each one involves the gas burner, venting or high-voltage controls, which is why a licensed gas fitter should handle the fix.
| What you notice | Likely cause we check | Why a licensed gas fitter handles it |
|---|---|---|
| Clicks, tries to light, then shuts off | Dirty or worn flame sensor, weak igniter, gas supply issue | Work happens at the burner and gas valve, inside the combustion area |
| Fan runs but only cold air comes out | Ignition failure, a safety switch has tripped, or a lockout | Safeties must be tested, never bypassed, before the burner runs again |
| Humming, then nothing happens | Draft inducer or pressure switch fault, blocked vent or condensate line | Venting faults can let combustion gases into the house |
| Short cycling on and off | Clogged filter, overheating, oversized furnace or thermostat issue | Overheating stresses the heat exchanger, which we inspect |
| Water pooling near the furnace | Blocked or cracked condensate drain or trap | Drain faults can trip safeties and damage the control board |
| Loud bangs, squeals or rattles | Delayed ignition, blower bearing wear, loose panels | Delayed ignition is a combustion issue that needs a gas technician |
| Status light blinking a pattern | A fault the control is reporting; meaning varies by model | We confirm the code against your furnace's manual before acting |
A quick check you can safely do: confirm the thermostat is set to heat and its batteries are good, and look at the filter in its slot. Anything beyond that, including resetting the furnace repeatedly, is best left to us.
Some of these problems are more common here than people expect. Our damp, mild winters mean furnaces run long, low cycles for months, so flame sensors foul and filters load up faster than many homeowners assume. High-efficiency furnaces with condensate lines running through cold garages or crawlspaces can freeze during a cold snap, and in many older Vancouver homes we find furnaces that were installed in a space never meant for one, which makes airflow and venting problems more likely.
Safety: if you notice a gas smell, have everyone leave, touch no switches, and call FortisBC's emergency line and 911 from outside; a CO alarm or unexplained headache or nausea means go outside and call 911.
What does ROMA do on a furnace repair visit, and how long does it take?
We confirm the symptoms with you, read the furnace's status light, test the ignition, flame sensing, safeties, venting and airflow, and check for gas leaks and carbon monoxide. Then we explain the fault and quote it in writing. Many common repairs are finished within an hour or two on the first visit.
Our technician's sequence on a typical call:
- We talk through what you've noticed, when it started and whether it happens on every cycle.
- We record the status-light pattern and check it against the manufacturer's information for your model.
- We watch a full heating cycle: inducer start, pressure-switch proving, ignition, flame, blower.
- We test the flame sensor signal, the igniter and the gas pressure, and leak-check the gas connections.
- We inspect the venting, condensate drain and trap, and check for CO at the furnace and in the living area.
- We inspect the heat exchanger where it's visible and look over the blower and filter.
- We quote the fix in writing, complete it with your approval, and re-test the full cycle before leaving.
If a furnace keeps failing, a maintenance plan with regular servicing often catches worn parts before they leave you without heat.
How fast can ROMA come out for furnace repair?
We book furnace repairs 7 days a week, and same-day visits are possible when the schedule allows. Call (604) 704-0300 or request a time online. We confirm a window and keep you posted, and we don't promise arrival times we can't keep.
When you book your repair, it helps to have:
- A photo of the furnace rating plate (model and serial details).
- Your description: "it's clicking but won't light", "it runs but blows cold", "it turns off after a few minutes".
- Any blinking-light pattern you noticed through the small viewing window.
- Access notes: basement, attic or crawlspace, parking, and strata rules for condos and townhouses.
Why hire a licensed local gas contractor for furnace repair?
Furnace repairs involve the gas burner, venting and combustion safeties, so they belong with a licensed gas contractor. ROMA holds Technical Safety BC licence Gas LGA0202903, is bonded and insured, and has repaired furnaces across Metro Vancouver since 1999.
- Upfront, flat-rate written quotes before any repair work starts.
- Permits through Technical Safety BC or the City of Vancouver when a repair becomes a replacement.
- 4.8★ across 221 Google reviews from Metro Vancouver homeowners.
- Free estimates on replacement furnaces and financing OAC if repair no longer makes sense.
- One team for furnaces, boilers, heat pumps, AC and water heaters.
We work on all common furnace brands without claiming special status with any of them. Our job is to find the fault and fix it properly.
Where does ROMA provide furnace repair service?
From our Burnaby office we repair furnaces across Metro Vancouver, including Vancouver, Burnaby, Richmond, Surrey, Coquitlam, Port Coquitlam, Port Moody, New Westminster, North Vancouver, West Vancouver, Delta, Langley and Maple Ridge.
Furnace acting up? Call (604) 704-0300 or email info@romaheating.ca and we'll get it looked at.
More questions we hear about this
How much does furnace repair cost?
It depends on the failed part, part availability, the furnace's age and how accessible it is. We diagnose first and give an upfront flat-rate written quote before doing any repair, so there's no surprise on the invoice. Call (604) 704-0300 or email info@romaheating.ca and we'll book a visit and confirm exact pricing.
Can you come today?
We book 7 days a week, and same-day furnace repair visits are possible when the schedule allows. Call (604) 704-0300 early in the day for the best chance. If we can't come right away, we'll give you the earliest window we have and keep you updated rather than promising a time we can't meet.
Is it worth repairing my older furnace?
Often yes, if the heat exchanger is sound and the fault is a single component. If repairs keep stacking up, parts are hard to find or the heat exchanger is damaged, replacement usually makes more sense. We give you the repair quote and, when it's relevant, a replacement quote too, so you can compare.
Is financing available if I need a new furnace instead?
Yes. If repair no longer makes sense, we offer free estimates on replacement furnaces and financing on approved credit (OAC). We'll show the flat-rate replacement price alongside a financed option. Rates depend on lender approval, so we explain current options on the phone or during your visit.
What Greater Vancouver Homeowners Say
“Nelson worked hard to get the NTI unit fixed. He was always polite, courteous and on time.”
“As always Nelson was super efficient. Showed up on time and was quick to work. I had a full maintenance done on the fireplaces and furnace. He was awesome. I won’t use anyone else.”
“Excellent service. Andy had a spare Carrier inducer with him which saved us time.”
“Was very prompt to respond to our issues. Technician was scheduled for the day following my initial call.”
“Very professional heating company. Price is reasonable, excellent work.”
“Highly recommend this company. It was a pleasure dealing with Shawn and Nelson.”
“Professional and courteous technicians with attention to detail and customer needs.”
“Always great, friendly service. Serviced the hot water on-demand system. Honest and informative. Thanks!”
“Speedy response time, honest, and professional service from start to finish.”
Why Greater Vancouver Trusts ROMA Heating & Cooling
ROMA Heating & Cooling has installed, repaired and maintained heating and cooling systems across Metro Vancouver since 1999. Our team are TSBC-licensed gas fitters (Gas LGA0202903) and Red Seal-trained technicians — licensed, bonded and insured — and we back every job with upfront, flat-rate pricing and a 100% satisfaction guarantee. We hold a 4.8★ rating from 221+ Google reviews.
- Authorized for 30+ brands (Lennox, Carrier, Viessmann, Navien, Rheem & more)
- Upfront flat-rate pricing — no overtime or hidden fees
- Free, no-obligation estimates on new installations
- Locally owned & operated in Burnaby, BC
No Hidden Fees
Our service rates are transparent and easy to understand. You approve upfront, flat-rate pricing before we start — so you never get a bill you didn’t expect.
Licensed & Bonded
ROMA is a TSBC-licensed gas contractor (Gas LGA0202903). Our technicians are bonded, insured and Red Seal-trained — qualified for any heating or cooling system.
Free Estimates
We offer free, no-obligation estimates on new installations — furnaces, boilers, heat pumps, air conditioners, tankless and hot-water tanks.
