Furnace 33 error code
Dirty air filters are a common cause of furnace cycling problems. Air filters trap dust, dirt and debris. With time, the filter becomes clogged and restricts airflow to the equipment’s heat exchanger. When this happens, the heat exchanger overheats, forcing the high-limit switch to trip and the furnace to cycle off.
Like many furnace manufacturers, Bryant uses flashing LED lights to indicate error codes that can give you an idea of what’s wrong with your furnace when it’s not functioning properly. The short flashes indicate the first digit of the two-digit code, and the long flashes indicate the second digit.
All furnaces are equipped with a reset button. They are generally red or yellow and are located inside the blower compartment. The reset button is a safety feature that will shut down the furnace when a problem is detected, often a hot or overheating furnace, before it trips the circuit breaker.
Most modern gas furnaces can be reset by turning off the power, waiting around 20 seconds, then switching the power back on. Other furnace models may exit lockout after 1-2 hours and attempt to power on again. If your furnace has a pilot light, you may need to relight it following the manufacturer’s instructions.
Press and release the raised red button at the center of the flame roll-out switch to reset the furnace. You can press the reset button up to three times before troubleshooting the furnace’s internal components or calling for repair service; allow 30 minutes between each reset.
If the high limit switch was bad, the furnace should not fire. When the high limit switch trips, the flame/heating element will be shut off and the blower will continue to run to clear the heat. The blower will continue to run until either the system is reset, or the limit switch closes.
The switch should be immediately suspect if the voltage drop is 0.2 VDC or higher (Fig. 1 indicates a bad limit switch). Verify that your ohmmeter will read “0” when the two leads are shorted together. The meter should read between “0” and “0.1” Ohms.
Remove the front door and look inside the unit. You should see the model number printed on rating-plate or decal.
Most likely, your furnace is making a clicking noise and not providing heat because your furnace’s spark igniter is trying to ignite your pilot light or burners but is failing to do so. In other words, there’s an ignition system malfunction that needs to be fixed. Otherwise, your furnace won’t start.
Press and hold the red “Reset” button in the center of the rollout limit switch component. Hold the button for one to two seconds before releasing it.
When the ignitor detects a flame, it tells the furnace to turn on the gas supply. Our technician will locate and remove the faulty ignitor inside your furnace, install a new one, and run your furnace through a heat cycle. This repair typically takes up to three hours and can range in cost from $180 to $300.
